Custom Guitar Knobs - Large Teardrop Style

This file is for a custom potentiometer knob for a guitar. The model is “Large Teardrop Style”. The knob is made up of 2 components; a top and a bottom portion. The top portion snaps into the bottom portion and a tiny locating pin helps ensure proper alignment. For me the fit was snug, but I still recommend a single drop of CA glue to make it permanent. The build plate is set as default to 3 per plate and the parts are print-by-object, so you can print all parts back-to-back and without a prime tower or swapping plates. Everything prints upside-down, so no supports and an excellent finish on the top surface! I think these would look really cool with a textured or patterned build plate as well. Fit is for the 6mm split-shaft style pot and is push-on. Double-check overall dimensions on these as well before printing. They are slightly larger than 0.875" wide, 1 3/8" long, and 0.6625" tall. Since these are quite large, there is potential for collision between the knobs if they