Thingiverse
Customisable Ring Box
door kajiiiii97
1
Downloads
2
Likes
0
Makes
Created this because I was procrastinating work.
It's customizable, just load it into your favourite 3D modelling software and change the diameters of the circles.
The holes on the sides are for 6mm magnets. You need 8 of them. Or, alternatively, you can extrude one side of the holes up past the surface by 3mm to make it like a peg fitting thingy. Just makes sure its not too tight or you might not see your ring again.
It's customizable, just load it into your favourite 3D modelling software and change the diameters of the circles.
The holes on the sides are for 6mm magnets. You need 8 of them. Or, alternatively, you can extrude one side of the holes up past the surface by 3mm to make it like a peg fitting thingy. Just makes sure its not too tight or you might not see your ring again.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
