Customizable Circle Toothpick Container

Tired of the look of plastic? Create a container using toothpicks. It looks fun, uses little filament and imports the look of wood with a very cheap material. Given that the main component here are toothpicks, if you use something a bit higher quality, the final look is going to be better. I created the black double floor using cheap material, and it does look good, but it was very inconsistent in height and rough on the surface. Print the “Ring” first to check if it fits your toothpick - it should slide through the hole entirely with no issue. If yours is on the thicker side, customize on the customizer and increase toothpick radius a bit. Regular 8cm size uses 64 toothpicks per layer. Customize your own toothpick size and spacing using the .scad file in the customizer. Assembly instructions, for a single layer container: Print Base, Ring and Finishing Add glue to the base. I used silicon glue, which has some viscosity but is slow to dry, so you can put a lot of sticks. Put the toothp