Thingiverse
Customizable Counterweight
von iwannabswiss
3
Downloads
0
Likes
0
Makes
This is a **3D-printable, customizable counterweight** —ideal for astronomy gear, DIY rigs, or camera setups.
By default, it's designed to fit a standard **20 mm counterweight shaft**, and you can fill the container with **BBs, sand, dirt**, or similar materials to achieve a total weight of up to **250 g (0.55 lbs)**. After filling, just **twist-lock the lid** in place for a secure and convenient counterweight.
The mounting hole is designed to be tapped for either a **M8x1.25** or **5/16-18** nylon screw, 25 mm (1 inch) long, to firmly attach it to your bar.
Want to tweak it? You can easily adjust the following parameters to match your setup:
- `counterweight_diameter`
- `counterweight_height`
- `counterweight_bar_diameter`
- `locking_screw_diameter`
**Print, fill, and balance—it’s that simple.**
By default, it's designed to fit a standard **20 mm counterweight shaft**, and you can fill the container with **BBs, sand, dirt**, or similar materials to achieve a total weight of up to **250 g (0.55 lbs)**. After filling, just **twist-lock the lid** in place for a secure and convenient counterweight.
The mounting hole is designed to be tapped for either a **M8x1.25** or **5/16-18** nylon screw, 25 mm (1 inch) long, to firmly attach it to your bar.
Want to tweak it? You can easily adjust the following parameters to match your setup:
- `counterweight_diameter`
- `counterweight_height`
- `counterweight_bar_diameter`
- `locking_screw_diameter`
**Print, fill, and balance—it’s that simple.**
iwannabswiss veröffentlicht auch auf
17 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
