Thingiverse
Customizable Hard Hat Inserts
von DKoss
783
Downloads
659
Likes
6
Makes
**4/2018** Customizer is back up and running apparently. Don't know what happened or when it happened. This feels like one of those "the fewer questions asked the better" type of situations.
**2/2018** Sorry everyone. Customizer is broken for this project and I'm not sure why. Thingiverse help say's they're looking into it. Until then try out OpenSCAD: http://www.openscad.org/ The .SCAD file is the same code that Customizer uses just a little less user friendly. Send me a message if you get stuck and I'll try to help.
**UPDATE No. 5**
Chatting with someone who has been customizing a lot of these I learned that they were further modifying the output with TinkerCAD. So I added a new tab "Non Hardhat Options" to add a button hole in the center of the tab, an option to add a counterweight and the ability to change the width (x) and length (y) of the tab. Changing any of these will likely make the tab unusable for hardhats.
I also took the chance to fix the error that was causing
**2/2018** Sorry everyone. Customizer is broken for this project and I'm not sure why. Thingiverse help say's they're looking into it. Until then try out OpenSCAD: http://www.openscad.org/ The .SCAD file is the same code that Customizer uses just a little less user friendly. Send me a message if you get stuck and I'll try to help.
**UPDATE No. 5**
Chatting with someone who has been customizing a lot of these I learned that they were further modifying the output with TinkerCAD. So I added a new tab "Non Hardhat Options" to add a button hole in the center of the tab, an option to add a counterweight and the ability to change the width (x) and length (y) of the tab. Changing any of these will likely make the tab unusable for hardhats.
I also took the chance to fix the error that was causing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
