Thingiverse
Customizable ring former
door stylesuxx
21
Downloads
11
Likes
0
Makes
For one of my projects I needed to bend a piece of flat Aluminium profile into a circle.
The aluminium sheet comes between the two parts which are then clamped onto the Aluminium, thus forming it.
From the radius I calculated how much Aluminium profile I needed an cut it to that size. I would recommend that you mark your length with a little bit of padding on both sides, because the end pieces do not bend very well.
If you leave some padding you can bend a full circle and than simultaneously cut off both paddings.
The aluminium sheet comes between the two parts which are then clamped onto the Aluminium, thus forming it.
From the radius I calculated how much Aluminium profile I needed an cut it to that size. I would recommend that you mark your length with a little bit of padding on both sides, because the end pieces do not bend very well.
If you leave some padding you can bend a full circle and than simultaneously cut off both paddings.
stylesuxx publiceert ook op
33 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
