Thingiverse
Customizable spool holder
von I_am_me
13
Downloads
5
Likes
1
Makes
Customizable spool holder, default values are for the Prusa xi3
Look at the instructions to see how to setup the spool holder.
Keep in mind that even if this is a customizable design you need to keep all values on a reasonable level or it will cause problems.
!! I did not verify the strength of the holder with all different values. I do not know how it will react with the weight of a spool.
YOU ARE USING THIS DESIGN AT YOUR OWN RISKS !!
Look at the instructions to see how to setup the spool holder.
Keep in mind that even if this is a customizable design you need to keep all values on a reasonable level or it will cause problems.
!! I did not verify the strength of the holder with all different values. I do not know how it will react with the weight of a spool.
YOU ARE USING THIS DESIGN AT YOUR OWN RISKS !!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
