Thingiverse
Customizable Stacking Loading Block V5
von Garshnokov
17
Downloads
10
Likes
0
Makes
This is a customizable reloading block / ammo flat container. This is a remix of Customizable Reloading Block by Jonathan Maia https://www.thingiverse.com/thing:4830571 and https://www.thingiverse.com/thing:5418495.
New Features:
- Added complete overhaul for hexagonal/offset placement (more compact for shipping/storage).
Notes:
- As before, consider vase mode properties are configured and align with SCAD settings.
- Consider additional tolerance for _Case Hole Diameter_ (e.g. 0.2mm) beyond nominal base width.
- For most compact use with hex-staggered/compact hole placement:
- _Holes Margin_ and _Holes Spacing_ should correspond to 1x and 2x line spacing accordingly (with some additional margin permitted by varied line width in slicer)
- See image for example settings (assuming 0.2 layer height and ~0.46 line width.
- Configurable text labels not recommended.
New Features:
- Added complete overhaul for hexagonal/offset placement (more compact for shipping/storage).
Notes:
- As before, consider vase mode properties are configured and align with SCAD settings.
- Consider additional tolerance for _Case Hole Diameter_ (e.g. 0.2mm) beyond nominal base width.
- For most compact use with hex-staggered/compact hole placement:
- _Holes Margin_ and _Holes Spacing_ should correspond to 1x and 2x line spacing accordingly (with some additional margin permitted by varied line width in slicer)
- See image for example settings (assuming 0.2 layer height and ~0.46 line width.
- Configurable text labels not recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
