Thingiverse
Customizeable Lens Cap
von joeynovak
1
Downloads
1
Likes
0
Makes
The defaults for this are for a 56mm lens (I used it for a Nikon DX 55-200mm lens).
Use the customizer tab in openscad to change it to suit your needs. It is just a slip fit, no latches, so if you make it the correct size (don't forget you can use decimals) it should fit just about any lens (or anything else you want to cap as well).
Use the customizer tab in openscad to change it to suit your needs. It is just a slip fit, no latches, so if you make it the correct size (don't forget you can use decimals) it should fit just about any lens (or anything else you want to cap as well).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!