MakerWorld
Animals
Ver Modelo
Cute Ghost Cat
1.2k
Descargas
571
Likes
649
Makes
No supports or brim needed! This adorable familiar prints directly on the bed with just a few color changes for the eyes and mouth. If you do not have an AMS or AMS lite, the eyes are 3D and can easily be colored with a sharpie, and the mouth is sculpted in so it should look fine without color.The example is printed at an accelerated speed, the layer lines will be less noticable if you do not speed the print up.If you like this print, check out my similar baby seal print here! https://makerworld.com/en/models/628646#profileId-553278Boost Me
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
