Cuvy Flyscreen

This is a draft design for a 7" headlight. I wanted something a little more curvy than a simple flyscreen. This is almost like a half fairing. Haven't printed it yet, but am expecting to need a fair amount of post processing to smooth out the surfaces.

I'm just lumping a few designs here:
-curvy_flyscreen: this one is ugly and weird, no judgements if you like it
-curvy_flyscreen2: a nice curvy shield, but I wanted something a bit longer
-curvy_flyscreen3 a longer curvy shield that should reach further back. Prob too tall for most printers

You'll need to play with orientation to get it to fit, I push one end below the print surface in Cura to make a little more height, you can also flip it and try sinking the other end into the print surface.

Most likely will need a wider brim for extra support at max height. I did a test print with spiralize on and it had trouble at the top of the print due to leverage and the piece moving around with the print head

The pictures are t