Thingiverse
Cyberdeck Case
por Harrison4257
41
Descargas
42
Likes
1
Makes
This is dystopian futuristic interpretation of a hobbled together laptop entirely 3d printed.
Hopefully not at all where we are heading for. :(
Still a work in progress.
The photos are experimental and are changeable.
Feel free to change the design of this and drill to your hearts content. I did XD
++Note++
I am left handed, if you are right handed, you can reverse everything in the 3d print (not the Raspberry Pi XD), either through rerouting your x+y wires; modifying the print in your Ultimaker pre-3d print software. Whatever your choice is yours alone :D
/++End Note++
It would be remis of me if I weren't dubious about the PLA carrier, it might in time snap off over time. So use best practices.
*You may have to sand the linear rails down a fair smidge to have them seat on and slide without much friction.*
*In the near future, I may pop the locating nubs off of the Raspberry Pi - Case and bore it down a smidge.*
*Some internal aspects aren't implemented as of yet.*
*Y
Hopefully not at all where we are heading for. :(
Still a work in progress.
The photos are experimental and are changeable.
Feel free to change the design of this and drill to your hearts content. I did XD
++Note++
I am left handed, if you are right handed, you can reverse everything in the 3d print (not the Raspberry Pi XD), either through rerouting your x+y wires; modifying the print in your Ultimaker pre-3d print software. Whatever your choice is yours alone :D
/++End Note++
It would be remis of me if I weren't dubious about the PLA carrier, it might in time snap off over time. So use best practices.
*You may have to sand the linear rails down a fair smidge to have them seat on and slide without much friction.*
*In the near future, I may pop the locating nubs off of the Raspberry Pi - Case and bore it down a smidge.*
*Some internal aspects aren't implemented as of yet.*
*Y
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
