Thingiverse
Cycloidal Drive
von Meia
54
Downloads
53
Likes
0
Makes
This is a cycloidal gearbox with a transmission ratio of 1:8.
In addition to the 3D-printed parts you will need 3 5x10x4 (dxDxW) bearings, 3 M4x20 bolts, 1 M5 bolt, 1 M3 bolt and a small 5mm washer.
If you put it together carefully and maybe sand it a little it will run very smoothly.
In addition to the 3D-printed parts you will need 3 5x10x4 (dxDxW) bearings, 3 M4x20 bolts, 1 M5 bolt, 1 M3 bolt and a small 5mm washer.
If you put it together carefully and maybe sand it a little it will run very smoothly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
