Thingiverse
Cyclone SYSClone
von ArjanNieuwenhuis
416
Downloads
325
Likes
2
Makes
Cyclone that will fit inside Sysainer t-loc 2
REQUIRED : 300mm x 300mm bed size.
i printed this on a Ender 3 Max
support that is needed varies part to part.
infill also varies from part to part.
Infill % / support / type of brim i used / type of ironing the part is listed below, including estimated print time for each part
Sys 2 t-loc Cyclone Base part#1 ABS 40% infill_in+out Brim 0.2 mm layer + iron 0.2 + Support 19h.30min
Sys 2 t-loc Cyclone Base part#2 ABS 40% infill_in+out Brim 0.2 mm layer + iron 0.2 + Support 6h.21min
Sys 2 t-loc Cyclone Inside part ABS 50% infill_Brim_0.2 layer_6h.23min
Sys 2 t-loc Cyclone Intake Loft ABS 25% infill Brim 0.2 Layer 4h.9min
Sys 2 t-loc Cyclone Lid Brackets ABS Brackets 20% infill + Brim 0.2 + iron 0.2 1h.45Min
Sys 2 t-loc Cyclone Suction loft ABS 25% infill + Brim 0.2 Layer 3h.50min
Sys 2 t-loc Cyclone Suction Suction Tube ABS 25% infill in+out Brim_Support_0.2 MM 6h.40min
Sys 2 t-loc Cyclone Systainer Tube
REQUIRED : 300mm x 300mm bed size.
i printed this on a Ender 3 Max
support that is needed varies part to part.
infill also varies from part to part.
Infill % / support / type of brim i used / type of ironing the part is listed below, including estimated print time for each part
Sys 2 t-loc Cyclone Base part#1 ABS 40% infill_in+out Brim 0.2 mm layer + iron 0.2 + Support 19h.30min
Sys 2 t-loc Cyclone Base part#2 ABS 40% infill_in+out Brim 0.2 mm layer + iron 0.2 + Support 6h.21min
Sys 2 t-loc Cyclone Inside part ABS 50% infill_Brim_0.2 layer_6h.23min
Sys 2 t-loc Cyclone Intake Loft ABS 25% infill Brim 0.2 Layer 4h.9min
Sys 2 t-loc Cyclone Lid Brackets ABS Brackets 20% infill + Brim 0.2 + iron 0.2 1h.45Min
Sys 2 t-loc Cyclone Suction loft ABS 25% infill + Brim 0.2 Layer 3h.50min
Sys 2 t-loc Cyclone Suction Suction Tube ABS 25% infill in+out Brim_Support_0.2 MM 6h.40min
Sys 2 t-loc Cyclone Systainer Tube
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
