Cyclops flippy bot

I could not leave well enough alone as looking at this design was just hollering for a cyclops eye on the front. I have quite a few of these eyes left over from the hungry bot project. I made the body as one piece to cover up the electrical wires more & used plastic 3d printed screws & 2 - 4" wire ties, so there the only hardware needed is the motor, battery case & batteries. I could cut down the weight on the body some by adding big holes in the side, bottom & back & putting tape over the holes. The threading idea I took from gzumwalt's hummingbird design (https://www.thingiverse.com/thing:2859291).

The threaded parts I used are M6 threading and a mating gap of 0.4mm. I print the threaded portions of the parts at .1mm. To modify any of the openscad files that use the threading, you will need to download the threads.scad file from http://dkprojects.net/openscad-threads/ . I put the settings for the threads in the ThreadSettings.scad file, so if you want to adjust the threading it