Cylinder Riser

This is a spacer to raise the cylinder slightly to make it easier to turn when weight is added to the knitting. I found that the cylinder was pressing against the cam shell too hard when weight is added. Please note that it does cause a little play with the other parts, especially the yarn carrier will move up and down very slightly. I tried different thicknesses and came up with .8mm thick that works well for me. If it's too thin, it's hard to print. If it's too thick, there is too much movement of the gear ring and yarn carrier.

You will need to adjust your layer settings because of how thin it is. It doesn't take long to print.
When installing, place it down first on the frame before adding the cam shell and cylinder.