Thingiverse
DA180 Collet Holder/Handle
door LilSpeedDemon87
0
Downloads
1
Likes
0
Makes
DA180 Collet Holder/Handle.
*Handle ONLY. Used nut from a Parlec CAT40 collet holder.
I made this in Fusion360, mainly to hold a reamer, to run back through intersecting holes to help clean up internal burrs. It was a pain to hold on to a CAT40 holder after awhile lol.
.375" hole all the way through handle.
0.12 Layer Height, 0 Infill/All Walls, 205 degree with 0.4 nozzle @ 50mm/s, fan speed 100%, brim.
*Handle ONLY. Used nut from a Parlec CAT40 collet holder.
I made this in Fusion360, mainly to hold a reamer, to run back through intersecting holes to help clean up internal burrs. It was a pain to hold on to a CAT40 holder after awhile lol.
.375" hole all the way through handle.
0.12 Layer Height, 0 Infill/All Walls, 205 degree with 0.4 nozzle @ 50mm/s, fan speed 100%, brim.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
