Thingiverse
Daemon Sword
door iPaintSmallThings
28
Downloads
13
Likes
0
Makes
I was making a Daemon Prince of Nurgle and thought a big square sword with three eyes along the blade would be dope and couldn't find one. I green-stuffed some eyelids and some meat-- highly recommend doing (can see via my Instagram @iPaintSmallThings). Also, making the spheres power orbs could be cool, too! I've included versions without the spheres as well.
Will need to be scaled down for smaller minis. I scaled it to ~75% to fit a human sized 28mm heroic scale mini. Also, when scaled down the print can be a little flimsy-- so I recommend using some super glue to reinforce the blade and the ring on the hilt.
The sword blade does not need supports if printed with the top of the blade on the print bed, but the hilt does. My hilt support instructions: Flip the print upside-down, rotate about 45%, and add some light supports on the bottom of the ring, the bottom of the hilt, and one in the center of the handle.
Printing the full sword shouldn't need supports. Just print it upside-
Will need to be scaled down for smaller minis. I scaled it to ~75% to fit a human sized 28mm heroic scale mini. Also, when scaled down the print can be a little flimsy-- so I recommend using some super glue to reinforce the blade and the ring on the hilt.
The sword blade does not need supports if printed with the top of the blade on the print bed, but the hilt does. My hilt support instructions: Flip the print upside-down, rotate about 45%, and add some light supports on the bottom of the ring, the bottom of the hilt, and one in the center of the handle.
Printing the full sword shouldn't need supports. Just print it upside-
iPaintSmallThings publiceert ook op
10 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!