Dancing Spinner

Dancing in the Wind! Here is another straight-forward wind spinner. Besides 3d printed parts, it uses common CD/DVDs, 1/2" PVC pipe, and readily available 608 bearings.

Thanks to https://DCDraws.weebly.com for the idea of badge on the stick. A great artistic focal point!

Balance it well and it will dance for you. Enjoy! https://www.youtube.com/watch?v=ctfOQ7mv9Kk

Hope you LIKE it. Check out my other designs at: https://www.thingiverse.com/aeromartin/designs

-AeroMartin

BOM:

CD or DVD: x8 (2 on the 15d holder)
608 Bearing (ID 8mm X OD 22mm X W 7mm): x4
1/2" PVC (OD:0.840" ID:0.622"): 65mm x1 + ~1.5m x1
1.6mmx8mm Screws: x3
CA Glue

Printing notes:

Infill:100%. Support everywhere (except alternative sticks). Brim or Skirt. PETG or PLA+. Use 15Deg holders on longer/top shaft to hold double CDs. Use 25Deg holders on the two shorter shafts.

Before gluing the badge for final balancing, you may add clay into the pointer cavity (at stick end) to add weight, or, print the pointer p