Thingiverse
Dart Case
von Ciabolo
86
Downloads
73
Likes
0
Makes
This is my design of a dartcase. It fits for most dart sizes but you can check the dimensions in the picture. You can print the body without support. Make sure, you print the lid on the side, although it looks a litle weired. The clamps will break at the layers if you print it with the flat side down.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
