Thingiverse
Models
Zum Modell
Dead tree
1k
Downloads
720
Likes
3
Makes
Sculpted a dead tree I was able to print it without supports at .1mm layers not sure if it could print at .2mm without supports
I included the .blend file if you want to make variations very beginner friendly
Just move the vertex points around in EDIT MODE with G
Press E for a new branch
Control + R to add a point in the middle
press Control + A to enlarge points
To add extra details in SCULPTING MODE apply all modifiers
enable dynamic typology
constant detail = 40
Clay Strips brush
I included the .blend file if you want to make variations very beginner friendly
Just move the vertex points around in EDIT MODE with G
Press E for a new branch
Control + R to add a point in the middle
press Control + A to enlarge points
To add extra details in SCULPTING MODE apply all modifiers
enable dynamic typology
constant detail = 40
Clay Strips brush
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
