MakerWorld
Hueforge & Lithophane
Zum Modell
deadpool hueforge
65
Downloads
35
Likes
35
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 150.78x214.44mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 3mm and the Actual Depth is 3.1mmFilaments Used: PLA Smartfil negro PLA Smartfil blanco PLA Smartfil Rojo This print uses 3 unique filamentsSwap Instructions: Start with negro At layer #7 (0.64mm) swap to blanco At layer #17 (1.44mm) swap to negro At layer #27 (2.24mm) swap to Rojo At layer #31 (2.56mm) swap to blanco for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
