Deadpool Wolverine hueforge

Note: I had a bad bed adhesion on the right corner, that is why I have a little black part there.Based on your filament choice the result may vary.Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mmThe Model is 150x148.94mm in sizeYou may print at higher layer heights below the Min Depth of 0.52mmThe Max Depth is 2.5mm and the Actual Depth is 2.5mmFilaments Used: PLA+ Sunlu Black Transmission Distance: 0.6 PLA+ Elegoo Red Transmission Distance: 3.5 PLA+ Elegoo Yellow Transmission Distance: 4 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #10 (0.92mm) swap to Red At layer #14 (1.24mm) swap to Yellow At layer #21 (1.8mm) swap to Jade White for the rest.