Thingiverse
DEC Multia Stand Base
por elb
0
Descargas
2
Likes
0
Makes
This is a stand for a DEC Multia desktop Alpha AXP computer. The original Multia stands are often missing or broken, but the Multia overheats easily when set down on the desktop. This stand design is different from the original, but more suitable for 3D printing. It is a very solid base, and a small clip retains it on the computer when moving the computer around.
The FreeCAD source is included. I am a poor modeler, so you get what you get.
The two end legs line up with the other two slots in the bottom of the Multia case; if you wanted a retaining clip in all three locations, you could put a 2.8 mm wide clip similar to the clip on the center leg somewhere near the inner face of the end legs. The end towers would have to be quite tall for that, however, and I didn't see the benefit.
b dka -fl a
-- elb
The FreeCAD source is included. I am a poor modeler, so you get what you get.
The two end legs line up with the other two slots in the bottom of the Multia case; if you wanted a retaining clip in all three locations, you could put a 2.8 mm wide clip similar to the clip on the center leg somewhere near the inner face of the end legs. The end towers would have to be quite tall for that, however, and I didn't see the benefit.
b dka -fl a
-- elb
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
