Decosnap Hooks V2 (Multiboard Hook)

Adapted this great organic design by @NateBorshch_2628425 to multiboard by adding a snap to his single hook. The inside of the snap has been reinforced to print upright. This is the second version of this remix and it should now be printable without any supports. No bed adhesion issues observed, so no brim was added. I mainly print on a BIQU Frostbite buildplate (since it is the best, no cleaning and less energy usage. I highly recommend it) but I did test on the powdered PEI sheet as well without issues. Test Printed in eSun ePLA Light I-Cold White, Elegoo (+ DEEPLEE) PLA Orange, Elegoo Rapid PETG orange + gray & Creality CR-PETG White. Based on the fantastic Multiboard system by Jonathan from Keep Making.A special license applies to Multiboard remixes. Full details of the Multiboard license: https://www.multiboard.io/license