Thingiverse
Delta Effector
door 3D_Lover
14
Downloads
13
Likes
0
Makes
Objective
1> Accurate bed leveling - detachable mount of the micro switch, no moving part to mount the switch firmly to achieve accurate z-height measurement.
2> Robust design to mount the hot end firmly
3> Dual 40mm Fan design (I just have a few 40mm fan at home)
4> Wind shield design to keep hot-end temperature constant.
3> Wire duct design for better cable management
4> 0.5W 0603 LED attached as lighting
Some recommendations:
1> Print support already drawn with the model. No additional support needed.
LED pcb board eagle file also included.
1> Accurate bed leveling - detachable mount of the micro switch, no moving part to mount the switch firmly to achieve accurate z-height measurement.
2> Robust design to mount the hot end firmly
3> Dual 40mm Fan design (I just have a few 40mm fan at home)
4> Wind shield design to keep hot-end temperature constant.
3> Wire duct design for better cable management
4> 0.5W 0603 LED attached as lighting
Some recommendations:
1> Print support already drawn with the model. No additional support needed.
LED pcb board eagle file also included.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!