Thingiverse
Delta Printer
door ossantiago
105
Downloads
87
Likes
1
Makes
This is my current project, after a failure with the purchase of a T1 I have decided to set up my own printer.
It is based on a frame of 300mm of side and 700mm of height, a warm bed of 220mm, and in the part of electronics I have used arduino + ramps + mosfet and the original power supply.
At this moment I am in the process of assembling the hot bed and everything points quite well. I will have to look for rods slightly longer than usual, about 250mm, but for the rest they are all standard components.
V1:
All parts finished, marlin latest 1.1.x firmware with autocalibrate and ubl, all works ok
https://youtu.be/ceAmDQwZq5o
It is based on a frame of 300mm of side and 700mm of height, a warm bed of 220mm, and in the part of electronics I have used arduino + ramps + mosfet and the original power supply.
At this moment I am in the process of assembling the hot bed and everything points quite well. I will have to look for rods slightly longer than usual, about 250mm, but for the rest they are all standard components.
V1:
All parts finished, marlin latest 1.1.x firmware with autocalibrate and ubl, all works ok
https://youtu.be/ceAmDQwZq5o
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
