Thingiverse
Delta spool support
von rokyed
7
Downloads
6
Likes
0
Makes
Very simple and elegant design.
Parts:
5x M4 Bolts and nuts.
7x washer
1x 608 bearing
NOTE: you might need a tiny bit of support (slic3r does a decent job)
Infill: 20%
Pattern: Honeycomb
Supports: yes (default settings)
Brim: yes (5mm)
Raft: 3 layers (default settings)
Layer height: 0.3mm
Parts:
5x M4 Bolts and nuts.
7x washer
1x 608 bearing
NOTE: you might need a tiny bit of support (slic3r does a decent job)
Infill: 20%
Pattern: Honeycomb
Supports: yes (default settings)
Brim: yes (5mm)
Raft: 3 layers (default settings)
Layer height: 0.3mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
