MakerWorld
Creatures
Zum Modell
Demon
9
Downloads
12
Likes
7
Makes
A 3d print of a demon covered in fur and spikes. I used PETG for the filament, but others should work fine as well. Takes about 155g of filament and 8 and half hours of print time. I focused on cutting down time while keeping quality, while at the same time, keeping tree supports easy to remove. I enjoyed this piece. If you do as well, please, leave a like, follow, or boost! Thank you!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
