Thingiverse
DepthKit Kinect Camera Offset Plate
door onebitpixel
9
Downloads
9
Likes
0
Makes
Simple camera plate adapter that allows you to shift your DSLR camera back if using longer lenses... a few lenses used obstructed the Kinect during filming.
Prints with little to no support - printed on its side @100% infill. Slot fits into the DepthKit 50mm aluminum bar and allows for added support using 1/4" through bolt; use a tac hammer to tap the plate all the way until the inner edge is flush with the edge of the aluminum bar. It uses the original 1/4" bolt to reattach the "manfrotto" camera mount on the top.
More info. on this project here:
http://www.depthkit.tv/
Interactive Documentary:
https://www.kickstarter.com/projects/1636630114/clouds-interactive-documentary/description
Prints with little to no support - printed on its side @100% infill. Slot fits into the DepthKit 50mm aluminum bar and allows for added support using 1/4" through bolt; use a tac hammer to tap the plate all the way until the inner edge is flush with the edge of the aluminum bar. It uses the original 1/4" bolt to reattach the "manfrotto" camera mount on the top.
More info. on this project here:
http://www.depthkit.tv/
Interactive Documentary:
https://www.kickstarter.com/projects/1636630114/clouds-interactive-documentary/description
onebitpixel publiceert ook op
32 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
