Deserted

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Gray Transmission Distance: 2PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Yellow Transmission Distance: 6This print uses 7 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #4 (0.64mm) swap to Blue GrayAt layer #5 (0.8mm) swap to GrayAt layer #7 (0.96mm) swap to Jade WhiteAt layer #10 (1.2mm) swap to RedAt layer #16 (1.68mm) swap to OrangeAt layer #19 (1.92mm) swap to Yellow for the rest.Boost MeGot a Boost to spare? Every little bit helps the motiva