Slicer Discord
Desk Extender – Modello 3D stampabile da Thingiverse Thingiverse

Desk Extender

5 Download
3 Likes
0 Makes
Vai al Modello
#studentdesignchallenge

I designed this desk extender so that it would be easier for me to take notes because I still sometimes use a paper notebook even though I am doing virtual learning and my laptop being right in front of me makes it hard to write especially when my desk is limited in space. The desk extender is made to bring your writing surface out so it is easier to write if you also have a laptop right in front of you. The extender has a hang down so that it is braced against the edge of your preexisting desk and goes back a bit so that your laptop can sit on top to provide a counterweight so something light like a notebook doesn't just tilt the extender towards you.

Questions:
1. What issues did you come up against?
Planning how I would go about doing this and getting the measurements because I didn't have a tape measure on me
2. If you could redesign this again what would you change?
I would probably figure out some way to make pieces to fit together becau
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione