Slicer Discord
Desk Extender – Modelo 3D imprimible de Thingiverse Thingiverse

Desk Extender

5 Descargas
3 Likes
0 Makes
Ver Modelo
#studentdesignchallenge

I designed this desk extender so that it would be easier for me to take notes because I still sometimes use a paper notebook even though I am doing virtual learning and my laptop being right in front of me makes it hard to write especially when my desk is limited in space. The desk extender is made to bring your writing surface out so it is easier to write if you also have a laptop right in front of you. The extender has a hang down so that it is braced against the edge of your preexisting desk and goes back a bit so that your laptop can sit on top to provide a counterweight so something light like a notebook doesn't just tilt the extender towards you.

Questions:
1. What issues did you come up against?
Planning how I would go about doing this and getting the measurements because I didn't have a tape measure on me
2. If you could redesign this again what would you change?
I would probably figure out some way to make pieces to fit together becau
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

5 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección