Thingiverse
DF64 Bellow Lid
von momptmakes
5
Downloads
4
Likes
1
Makes
Customer lid for DF64 hopper/bellow. The lid doubles up as a dosing cup that you can weigh into and attach to the bellow.
The cup has a volume of ~90ml and big enough to dose up to 30g of beans.
Rev 2.2 has a slightly more angled chamfer on the top/bottom of the lid.
Rev 2.3 has a curved finish, may be more aesthetically pleasing depending on your preference.
Rev 2.4 has a higher wall chamfer - easier angle for 3d printing.
Rev 2.5 has no chamfer on the lid.
This is compatible with most Aliexpress rubber hopper belows e.g.
https://www.aliexpress.com/item/1005004036489936.html?spm=a2g0o.order_list.0.0.5252180286EIle
The cup has a volume of ~90ml and big enough to dose up to 30g of beans.
Rev 2.2 has a slightly more angled chamfer on the top/bottom of the lid.
Rev 2.3 has a curved finish, may be more aesthetically pleasing depending on your preference.
Rev 2.4 has a higher wall chamfer - easier angle for 3d printing.
Rev 2.5 has no chamfer on the lid.
This is compatible with most Aliexpress rubber hopper belows e.g.
https://www.aliexpress.com/item/1005004036489936.html?spm=a2g0o.order_list.0.0.5252180286EIle
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
