Thingiverse
Diffraction grating and single slit
door dimonoid
8
Downloads
5
Likes
0
Makes
Print slit twice, and grid once.
You can increase/decrease the width of slit by using 2 of them simultaneously, or for different experiments with interference and diffraction.
Can do 2 experiments:
1) 1 slit near light source and 2nd slit near observer. Can be seen only diffraction pattern.
2) 1 or 2 slits near light source and diffraction grating near observer. Can be seen both diffraction and interference patterns.
Caution! Never look straight at lasers unless you 100% know it is very low power!
Instead of a laser recommended to use used single color LEDs which are much safer!
As an alternative, you can use a flashlight from a phone, but then the diffraction pattern is very hard to see.
You can increase/decrease the width of slit by using 2 of them simultaneously, or for different experiments with interference and diffraction.
Can do 2 experiments:
1) 1 slit near light source and 2nd slit near observer. Can be seen only diffraction pattern.
2) 1 or 2 slits near light source and diffraction grating near observer. Can be seen both diffraction and interference patterns.
Caution! Never look straight at lasers unless you 100% know it is very low power!
Instead of a laser recommended to use used single color LEDs which are much safer!
As an alternative, you can use a flashlight from a phone, but then the diffraction pattern is very hard to see.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
