Slicer Discord
Diffuser Station Essential Oils – 3D-Druckmodell von Thingiverse Thingiverse

Diffuser Station Essential Oils

von GenCab
207 Downloads
128 Likes
0 Makes
Zum Modell
Check out my etsy store. https://www.etsy.com/shop/HotSquare
Diffusers for Essential oils have become very cheap in the past few years. I have noticed there is a general size and form to the cheap ones sold on Amazon. They typically come with a pre-measured water cup. So I wanted everything to stay in one place without the risk of loosing the little cups and perhaps have a few oils to have on hand for easy refills. So I quickly wiped this up. Its a simple design that made the most since to me. Four slots for the standard Essential oils bottle size "Also works for a majority of off brand", recess on the top to hold whatever accessory you might need without it rolling away, space in the back for the fill cup, and drain holes.

This is washable if you get a spill or oil leak. Every crevasse has a drain hole allowing you to flush out anything you might need to get rid of.

PLA does not react well to some Essential oils. I have no idea what oil has a negative effect but I noticed one
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

GenCab veröffentlicht auch auf

23 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen