Thingiverse
Digirig Case
von Geardwn
8
Downloads
8
Likes
1
Makes
This is a 3d print for a replacement of the standard Digirig case. It significantly reduces the size of the unit. It was designed for a 0.4mm nozzle size and is bext printed vertically with no support. The cover is attached with a #2x1/4" long flat head screw.
UPDATE 1/11/2023
Added FreeCad files.
UPDATE 2/10/2021
Digirig changed the mounting of the Audio and Serial jacks to a through hole which has pins that protrude down. V2.0 adds 2mm of clearance below the slot for the board. I do not have one of the new boards to test the changes. Jason KM4ACK notified me that his board was the new one and didn't fit. He will test the changed case when he gets back next week.
Optionally you might trim the pins but there is only 0.5mm (.02") clearance to the bottom of the board in the original design.
UPDATE 1/11/2023
Added FreeCad files.
UPDATE 2/10/2021
Digirig changed the mounting of the Audio and Serial jacks to a through hole which has pins that protrude down. V2.0 adds 2mm of clearance below the slot for the board. I do not have one of the new boards to test the changes. Jason KM4ACK notified me that his board was the new one and didn't fit. He will test the changed case when he gets back next week.
Optionally you might trim the pins but there is only 0.5mm (.02") clearance to the bottom of the board in the original design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
