MakerWorld
Other Toys & Games
Zum Modell
Disc Golf Bracket
9
Downloads
4
Likes
5
Makes
Tired of your Disc falling off the mounts? I was too! My disc holder is a two-piece system with clearances modeled in for mounting with screws. Unfortunately, I can not specify which size I modeled off of since I grabbed something around the house. However, I can say these have been hanging in my non-climate-controlled garage for years over a workbench with no issue. I haven’t picked up a disc off the floor since putting these up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
