Dishwand Holder

Update 11/19/24:I have updated the model to have a lip on front. This is so it can catch the lip of the sink. This should stop it from sliding around. Additionally, I add a few circular feet on the bottom. This is allow a little bit of air flow to get along the bottom, trying to make sure there is not always water between the countertop and bottom of the dishwand holder. I created a dishwand holder. It is meant to sit on the edge of the sink so that water from the dishwand will fall back into the sink. It is design to hold all different kinds of dishwands. It designed so that dishwand will never be sitting in water and everything will drain of of it. Additional, I have added small diamond shaped features on the surface that the dishwand sits. This help whatever dishwand that is put it for moving/sliding around. In the print profile I have uploaded. There are 2 sheets. Each sheet has the same model. Sheet 1, the model prints from the back forward, its the fastest print time with the lea