Thingiverse
Display case
por Tircown
11
Descargas
6
Likes
0
Makes
This case is made for a "SmartRepRapDiscount Full Graphic Smart Controller" and a breakout board made to allows connection of the LCD through an USB cable thanks to an Arduino nano. One should use Klipper firmware to perform this task. The breakout board I use is a "Nano_Display" developped by the Voron community. Big thanks to them.
Print 2x the spacer and put them on each side between the two boards of the SmartRepRap Display. This allows you to tight the screws to close the case without damaging the display.
Secure the Nano_Display with double sided tape at the bottom.
Use 4x inserts nuts and 4x M3x15 to close the case.
The bottom part needs supports.
Print 2x the spacer and put them on each side between the two boards of the SmartRepRap Display. This allows you to tight the screws to close the case without damaging the display.
Secure the Nano_Display with double sided tape at the bottom.
Use 4x inserts nuts and 4x M3x15 to close the case.
The bottom part needs supports.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!