DIY Simulator Pedals

This is a singular pedal system, designed to be arranged with one, or two more, to create a set of Arduino driven racing pedals. I currently do not have the electronics to complete this project. but the 3D files are complete. The pedals should be mounted on some sort of panel. I'll be using a 2x6.

You will need to print one of each part.

(UPDATE) Depending on how you print the pieces with have rubberband hooks on them, they will fail under very little stress. I've added rubberband_v2.stl to replace the printed hooks. This new design has enough surface area to superglue to the area needed.

-128lever_V2.stl is mounted to pedalcase_V1.stl with a generic 608 bearing.

-arm_V1.stl fits into 128lever_V2.stl and pedaljoint_v1.stl
You may need to scale these a TINY bit. But on my printer, this has a very strong friction
fit.

-pedal_V1.stl is connected to pedaljoint_v1.stl with the pedal_pin_V1.stl
You should place rubber bands on each hook on either side of the pedal, conn