Thingiverse
Document capsule
von tlo
35
Downloads
39
Likes
0
Makes
I printed this to keep the seed for a trezor hardware wallet.
The idea is to make shure the seed has not been compromised (read) by any person.
Therefore the paper gets inserted during the printprocess of the closed closed object.
Once the print has finished the paper can only be removed by breaking the capsule.
Of cause any paper can be inserted as long as it fits physically.
Printed using spiral vase. But it should print normal as well, but it will probably need more force to break it, depending on your outer shells.
Once the print has reached a reasonable height, pause the print lift the noozle up by 100mm or so. Insert the paper, manual extrude some filament and move the noozle exactly the same amount down you moved it up before. Then resume the print.
Once finished the paper should be enclosed completely.
Update:
The model seedcapsule_scaled.stl had a tiny hole at the top which some slicers had problems with to close the top.
seedcapsule_closed.stl should fix that.
The idea is to make shure the seed has not been compromised (read) by any person.
Therefore the paper gets inserted during the printprocess of the closed closed object.
Once the print has finished the paper can only be removed by breaking the capsule.
Of cause any paper can be inserted as long as it fits physically.
Printed using spiral vase. But it should print normal as well, but it will probably need more force to break it, depending on your outer shells.
Once the print has reached a reasonable height, pause the print lift the noozle up by 100mm or so. Insert the paper, manual extrude some filament and move the noozle exactly the same amount down you moved it up before. Then resume the print.
Once finished the paper should be enclosed completely.
Update:
The model seedcapsule_scaled.stl had a tiny hole at the top which some slicers had problems with to close the top.
seedcapsule_closed.stl should fix that.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
