Doggy Button

See / edit it here in Fusion 360: https://a360.co/2UGFDIZ

WORK IN PROGRESS
=================

This is a training toy for dogs.
You can put a treat (~1cm size) in the hole at the top that will be dispensed when the button in pushed.

Parts
====

* Rubber bands to the length of your liking
* 3x M3-inserts (3*4*4 size)
* 3x M3x10 round head screws
* 3x 4cm PTFE tube, 4mm diameter (optional)
* 1x Bottom
* 1x Insert
* 1x Deckel
* 3x Plug (for the bottom)
* 3x Plug2 (for the top)

(The plugs probably don't matter where you put them, but the one of them is just slightly shorter)

Assembly
=======

If you use the optional PTFE tubes so it slides better:
* Insert the PTFE tubes into the slots at the corners of the "inlay" print
* Slowly insert the insert into the bottom part. If it doesn't slide free, sand/cut the outside of the tube a bit until it slides with little resistence

* Insert the M3 brass inserts as shown with a soldering iron or a matching tool
* Ass