Thingiverse
Don't Panic Button
por rob2000000
7
Descargas
15
Likes
0
Makes
Just a 50mm Don't panic button /badge - swap filament for the top 3 layers for dual colour.
I have added magbutton.stl - this version has a 10x1mm hollow inside - with layer heights all at 0.2 , pause at layer 9 - place a 10x1mm magnet and resume printing. Filament change at layer 26 to get a two colour badge.
Brass nozzle only when using strong neodymium magnets.
I tried the magbutton version but the hollow proved a bit small for the 10x1mm magnet - Will try 103% scaling to see if it fits.
New Magnet Button2.stl - 10x1mm magnet fits perfectly - filament change should be at layer 27
- I got it a bit wrong so my colours are not as intended
- the small cylinder is a blob catcher for the coulour change
I have added magbutton.stl - this version has a 10x1mm hollow inside - with layer heights all at 0.2 , pause at layer 9 - place a 10x1mm magnet and resume printing. Filament change at layer 26 to get a two colour badge.
Brass nozzle only when using strong neodymium magnets.
I tried the magbutton version but the hollow proved a bit small for the 10x1mm magnet - Will try 103% scaling to see if it fits.
New Magnet Button2.stl - 10x1mm magnet fits perfectly - filament change should be at layer 27
- I got it a bit wrong so my colours are not as intended
- the small cylinder is a blob catcher for the coulour change
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
