Thingiverse
Door Hinge Cap
von pmhesse
0
Downloads
0
Likes
0
Makes
My screened in porch had a door with a very squeaky hinge.
The bottom of the hinge had a plastic cap, which in the course of removal, I cracked.
This is a replacement for that part. It fits my hinge perfectly, with the cap being 11mm wide, the plug section being 8mm wide with a 5mm hole for the hinge pin.
I printed this at 0.08mm layers although not sure that fine detail was necessary.
100% infill
PETG or ABS is recommended for outdoors.
The bottom of the hinge had a plastic cap, which in the course of removal, I cracked.
This is a replacement for that part. It fits my hinge perfectly, with the cap being 11mm wide, the plug section being 8mm wide with a 5mm hole for the hinge pin.
I printed this at 0.08mm layers although not sure that fine detail was necessary.
100% infill
PETG or ABS is recommended for outdoors.
pmhesse veröffentlicht auch auf
12 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
