Thingiverse
Door_Puller
por technodoug
1
Descargas
2
Likes
0
Makes
Simple extension handle to extend reach to aid in pulling car door closed.
The hand guard is helpful to improve grip, reduce possibility of dropping, and makes it easier to retrieve the part from a door storage pocket.
Single part is about 14.5 inches long, so it may need to be split using slicer. The short model is scaled down from the original (85% in x and y) to fit on a 256x256mm plate like Bambu Lab X1C (about 12.25 inches long)
Also have separate models for the handle and the tip that are connected using M3x16 screws and nut. (I used self-locking M3 nut). Can also be CA glued together.
Support required for the filleted features and screw heads and nuts.
I printed using PETG to handle high temperature of car interior.
The hand guard is helpful to improve grip, reduce possibility of dropping, and makes it easier to retrieve the part from a door storage pocket.
Single part is about 14.5 inches long, so it may need to be split using slicer. The short model is scaled down from the original (85% in x and y) to fit on a 256x256mm plate like Bambu Lab X1C (about 12.25 inches long)
Also have separate models for the handle and the tip that are connected using M3x16 screws and nut. (I used self-locking M3 nut). Can also be CA glued together.
Support required for the filleted features and screw heads and nuts.
I printed using PETG to handle high temperature of car interior.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
