Double sided Axe

I was inspired to design a double headed battle axe with Celtic symbols on it. It was a good challenge to figure out the best ways to get this to fit together as it is way to big for one print job. I would recommend printing the axe heads with the outer face on the print bed. Although you may have some minor gap between the blades the amount of layering if the outer face it upwards is very noticeable. Make sure you have supports set up. I use tree supports. You will need to print four (4) of the axe heads but i didn't make different print plates (you can just print that one four times) I ended up painting mine to get a little bit different color. Enjoy