Slicer Discord
Double-Slit Experiment Model – 3D-Druckmodell von MakerWorld MakerWorld
Physics & Astronomy

Double-Slit Experiment Model

45 Downloads
65 Likes
15 Makes
Zum Modell
This model depicts Thomas Young's double-slit experiment from 1801, proving that light also behaves as a wave. The theory surrounding this experiment predicted that, if light is a wave, it should show both constructive and destructive interference when passing through a double slit. Contact with the slit creates a new starting point for a propagating wave (shown by the concentric circles and their origins). These new waves interact with each other both constructively and destructively, creating a repeating series of progressively dimming lines on the far wall starting at the center. I have added the waveform on the far wall that mathematically describes the dimming lines that would appear (roughly a sync function, but not exactly). This model can also be stood up as a Christmas Tree for a perfect Christmas decoration for science lovers! Add some glue to the square posts protruding from the base (the part with the words) to make sure that the light bulb and the far wall are stuck se
Kategorie
Physics & Astronomy
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen