Thingiverse
Double Throwie Cases
von 1000000000user
1
Downloads
3
Likes
1
Makes
This is a pair of almost identical casings for throwies which fit together in several different ways and allow easy access to the LEDs so that it is easier to replace any dead battery. This was designed in tinkercad and printed using a MakerBot. I used 6x3h,10d=m, 2x6.5d,1m=m, Li3V coin cell 5mm LED
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
