MakerWorld
Sculptures
Vai al Modello
Dragon Bust
39
Download
54
Likes
12
Makes
Hi guys, hope you like this new Dragon bust:) Feel free to scale it if you would like to print it bigger or smaller. I recommend to use pliers to carefully remove the support. I usually grab the support rather close to the connection, slightly wiggle it around to loosen it before pulling it off:) If you would like to sell prints of my models check out my commercial license on my Patreon or subscribe directly here on Makerworld: https://www.patreon.com/c/TreeDprintsAlso check out my other models here: https://makerworld.com/en/@TreeDprints
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
